殼芯機如果要發揮最佳效果的話，就需要掌握殼芯機的使用方式和了解正確的殼芯機的操作流程，具體如下：

If the shell core machine is to give full play to its best results, it is necessary to master the way of using the shell core machine and understand the correct operation process of the shell core machine.

1、檢查傳動鏈條的松緊度是否適中，如過緊或過松，應予調整。

1, check whether the tightness of the transmission chain is moderate, if it is too tight or too loose, it should be adjusted.

2、接通電源，擰開壓縮空氣伐門，先有手動方法，對各機構逐個點動試車，然后用自動方法，進行一個循環試車，確認一切正常后，方可進行生產。

2, connect the power supply, unscrew the compressed air cutting door, first manual method, the various agencies to move the test by one by one, and then use the automatic method, a cycle test, confirm all normal, can be produced.

3、設備開動后，一個循環未完成時，不許中途調整電器，以免產生誤動作，造成設備人身事故。

3, when the equipment is running, when a cycle is not completed, it is not allowed to adjust the appliance halfway, so as to avoid misoperation and cause equipment accident.

4、設備每運轉一個循環之后，必須用噴咀將芯盒上的殘存砂子吹去。

4, after each operation of a cycle, the nozzle must be used to blow away the remaining sand on the core box.

5、如果用手操作，不準同時操作兩個以上電器開關。

5, if you operate with your hands, you must not operate more than two electrical switches at the same time.

6、在工間休息時，必須將煤氣關小，以免燒壞芯盒。

6. During the rest time, the gas must be turned off to avoid damaging the core box.